If it already says partition(1), change it to partition(2). To resolve a blank screen on startup with a flashing cursor, try changing partition(2) to partition(1) in both places. You may need to remove a read-only and/or hidden attribute from boot.ini before you can edit it. Multi(0)disk(0)rdisk(0)partition(2)WINDOWS=”Microsoft Windows XP Professional” /noexecute=optin /fastdetect You can use a rescue disk such as BartPE or a Windows XP installation CD to get to a command prompt and edit boot.ini, which looks something like the following:ĭefault=multi(0)disk(0)rdisk(0)partition(2)WINDOWS If you’ve just rebuilt or re-imaged a Windows XP computer and see a blank screen on startup with a blinking cursor, look at the boot.ini file. It appears most common in laptops but can happen on many brands of laptops or desktops, including Dell and Lenovo. This can happen even if you have disabled USB drives as possible boot devices in BIOS. Plug in each device one by one, restarting each time, to isolate which is causing the problem. If your computer starts normally, try reconnecting the USB devices after Windows loads. Disconnect any USB devices other than a wired keyboard and wired mouse. The first thing to check is whether you have a USB flash drive or USB hard drive plugged in, or any type of USB dongle, perhaps for a cordless mouse or keyboard. The computer may or may not start successfully in Safe Mode. The black screen might include a blinking cursor, usually in the upper left corner of the screen, or a mouse pointer in the middle of the screen. The frustrating black or white screen problem can happen on Windows XP, Windows Vista or Windows 7, and it may happen intermitently. If your Windows computer stalls at a black or white screen at startup, these steps could help get your computer going again.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |